125 results found for MIL-STD-883
Reference
Title
Source
Type / Subtype
Date
Issue / Rev
Status
This method establishes the procedure for measuring the ground bounce (and VCC bounce) noise in digital microelectronic devices or to determine compliance with...
DLA
Method
/
Active
total dose test of the HS-OP470ARH.Parts were tested at low and high dose rate under biased and unbiased conditions as outlined in MIL-STD-883 Test Method 1019.7,to a...
TD
/ 0
Active
The purpose of this test is to verify that the amount of Lead (Pb) in Tin-Lead (Sn-Pb) alloys and electroplated finishes contain at least 3 weight percent (wt%) Lead...
DLA
Method
/
Active
The purpose of this test is to determine the strength of the element attachment system when subjected to force in the Y1 axis. This method is applicable to...
DLA
Method
2 /
Active
Both the IS-139ASRH and IS-139ASEH are wafer-by-wafer assurance tested per MIL-STD-883H at 300krad(Si) of HDR (50 to 300 rad(Si)/s. Only the IS-139ASEH is...
TD
/ 0.00
Active
This method establishes the minimum inspection procedures and acceptance criteria for polymeric materials used in microcircuit applications.
DLA
Method
7 /
Active
The purpose of this test method is to determine the solderability of all ribbon leads up to 0.050 inch (1.27 mm) in width and up to 0.025 inch (0.64 mm) in thickness...
DLA
Method
3 /
Active
This method establishes the means for measuring the automatic gain control range of a linear amplifier.
DLA
Method
/
Active
Method 5008 is canceled effective 1 June 1993. It is superseded by MIL-PRF-38534. For Federal Stock classes other than 5962, the following paragraphs of MIL-PRF-38534...
DLA
Method
9 /
Cancelled
Samples were tested at low and high dose rate under biased and unbiased conditions, as outlined in MIL-STD-883 Test Method 1019, to a total dose of 100krad(Si) at LDR...
TD
/
Active