460 results found for MIL-STD
Reference
Title
Source
Type / Subtype
Date
Issue / Rev
Status
The purpose of this test method is to determine the solderability of all terminations which are normally joined by a soldering operation.
DLA
Method
A /
Active
The purpose of this test method is to measure the static characteristics (Vp, Vv, Ip, Iv, VFP, and Rd) of the tunnel diode under the specified conditions
DLA
Method
1 / w/Change3
Active
This method establishes the means for measuring the automatic gain control range of a linear amplifier.
DLA
Method
/
Active
Method 5008 is canceled effective 1 June 1993. It is superseded by MIL-PRF-38534. For Federal Stock classes other than 5962, the following paragraphs of MIL-PRF-38534...
DLA
Method
9 /
Cancelled
The purpose of this test is to determine the time required for the DUT to switch off when a reverse bias is applied after the DUT has been forward biased and to...
DLA
Method
1 / w/Change1
Active
The purpose of this test is to determine the effectiveness of circular jacketed cable to plug interface, or flat cable to plug interface to withstand strain under...
DLA
Method
/ A
Cancelled
The purpose of this test is to permit evaluation of the proparties of materials used in connectors as they are influenced or deteriorated by the effects of high...
DLA
Method
2 / A
Cancelled
The purpose of this test is to establish the methods and procedures to be followed in determining the resistance offered by the insulation materials and the various...
DLA
Method
1 / A
Cancelled
It is the purpose of this test to determine the percentage change in direct-current (dc) ohmic resistance from the dc ohmic resistance at the reference temperature,...
DLA
Method
/
Active
This test method covers a method of measuring case temperature of hex-base semiconductor devices.
DLA
Method
1 / A w/Change4
Active